Subject: Tango motor mount redesign for lower cost
From: rotaryeng
Date: 1/21/2013, 5:51 PM
To: AAAA-rotaryeng



  Alex, with a few changes to the water pump
  and intake plenum I can use a simple top mount
  and simplify the main motor mount greatly.

  You will need to add a hard point to the top of the
  firewall at the center. This is a real old idea used
  by Power Sport 20 years ago.

  Paul Lamar

  Here is what the low cost version of the Tango mount with the
  top motor mount. Fewer laser cut tubes and welded joints.
  Rotary installation is driven by cost.

  I had an idea on how to mod an off the shelf car shock
  and convert it to an air spring.

  Drill a hole and drain the oil. Tig weld or braze a pipe
  fitting on. refill with oil and plumb to an air pressure
  can.

  Paul Lamar

  You can buy shocks that way now. Takes the fun out of when the shock
  will blow up when the oil vapourizes from the heat.

  Dale Davies

  Got any specific car model suggestions Dale.
  Preferably something heavy like a sport ute or pickup truck.

  Got any junk ones lying around I can play with and test.
  I'll pay shipping. I need mono tubes.

  Paul Lamar

   Here are some pics, unfortunately i am not in the USA at the
  moment to take more pics but the one pic shows the water pump outlet
  mods Milo did, its not a slide throttle on this one, the intake
  plenum is on the side of the intake so it should be easier to attach
  the top supporting strut to the top of the engine and the top centre
  of the firewall, i'd like to turn the intake around and have it
  facing relative airflow rather than the firewall, net me a bit of
  ram air pressure, I'd also like to look at p-porting as a project
  for later down the line once she's flying and proven, but i guess i could
  route the pipes around the top MM strut somehow,

   Alex

  Ah so stock RX8 water pump.
  P-port and slide throttle.
  If so you will need an WP adapter block.

  Paul Lamar


  What you want is "remote reservoir shocks" for off road apps. I give the site
     for Bilstein only. Search off road shocks and other manufacturers will be listed.

    <http://www.4wheelparts.com/parts/bilstein/shocks.aspx


     Off road should give the weight capacity you are looking for and you should be
     able to vary the air or gas charge in the reservoir for tuning.

     Dale Davies


  Paul, the average tango nose wheel weight is 289lbs,
  Alex


  OK Alex. Thanks. That means we will need about 900 pounds
  on the shock strut. Looks like time for an aux die spring.

  Paul Lamar

 Just to be helpful...  We used a spring from a  mountain-bike rear
  suspension for our nosewheel install.

 Chris Cosman

 Nice work Chris. What damps it? :)

 Paul Lamar

 Chris, got any pictures of the complete fuse without covering?

 Paul Lamar

Yep.  Keep in mind, this is the prototype, so there is WAY more structure than there needs to be.  The nosewheel/ firewall integration was an afterthought.  It will all be altered on the beta prototype.

Chris Cosman

Cool Chris. A real bird cage Maserati look a like  :)

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.