Paul:
I have a little used RX-8 high-power engine I'd like to convert to PP
INTAKE to
use on my COZY IV. I do have Tracy's
2.85-1 reduction drive.
Is it worth it-------------should I start with an RX-7 engine to get
PP exhaust
and then convert to PP intake?
I presume no issues if I want lightweight end housings.
Thanks and regards,
cozyflyr
Stick with the RX8 p-port. The best of both worlds.
due to the side exhaust on the RX8 it idles as well as stock
13B. Don't waste your time with a side port engine.
Sure an heck don't pay somebody big bucks to "port"
a side port engine. That is a gross waste of money.
Paul Lamar
Thanks Paul:
So I understand it is OK to tear down my RX-8 and send the housings
down to Jeff Dodridge for the P-port intake bore job
and welding of 2" dia. tube?
Then for a lightweight engine I could buy the aluminum end and center
housings?
Regards,
cozyflyr
I am not sure jeff does welding but he could send them to
mazdatrix for tig welding and finish grinding. They have done
several.
Paul Lamar
I have a guy here that does it for $25 each, it's a deal, he is very
good..
jeff
Thanks Jeff. I'll put that on the web site.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.