Subject: To P-port ort not to P-port
From: AAA-rotaryeng
Date: 1/24/2013, 8:29 PM
To: AAA-robin Lamar


Paul:

I have a little used RX-8 high-power engine I'd like to convert to PP
INTAKE to
use on my COZY IV. I do have Tracy's
2.85-1 reduction drive.

Is it worth it-------------should I start with an RX-7 engine to get
PP exhaust
and then convert to PP intake?

I presume no issues if I want lightweight end housings.

Thanks and regards,


cozyflyr


Stick with the RX8 p-port. The best of both worlds.
due to the side exhaust on the RX8 it idles as well as stock
13B. Don't waste your time with a side port engine.

Sure an heck don't pay somebody big bucks to "port"
a side port engine. That is a gross waste of money.

Paul Lamar

Thanks Paul:

So I understand it is OK to tear down my RX-8 and send the housings
down to Jeff Dodridge for the P-port intake bore job
and welding of 2" dia. tube?

Then for a lightweight engine I could buy the aluminum end and center
housings?

Regards,
cozyflyr

I am not sure jeff does welding but he could send them to
mazdatrix for tig welding and finish grinding. They have done
several.

Paul Lamar

I have a guy here that does it for $25 each, it's a deal, he is very
good..

jeff

Thanks Jeff. I'll put that on the web site.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.