Paul:
I have a little used RX-8 high-power engine I'd like to convert to PP
INTAKE to
use on my COZY IV. I do have Tracy's
2.85-1 reduction drive.
Is it worth it-------------should I start with an RX-7 engine to get
PP exhaust
and then convert to PP intake?
I presume no issues if I want lightweight end housings.
Thanks and regards,
cozyflyr
Stick with the RX8 p-port. The best of both worlds.
due to the side exhaust on the RX8 it idles as well as stock
13B. Don't waste your time with a side port engine.
Sure an heck don't pay somebody big bucks to "port"
a side port engine. That is a gross waste of money.
Paul Lamar
Thanks Paul:
So I understand it is OK to tear down my RX-8 and send the housings
down to Jeff Dodridge for the P-port intake bore job
and welding of 2" dia. tube?
Then for a lightweight engine I could buy the aluminum end and center
housings?
Regards,
cozyflyr
I am not sure jeff does welding but he could send them to
mazdatrix for tig welding and finish grinding. They have done
several.
Paul Lamar
I have a guy here that does it for $25 each, it's a deal, he is very
good..
jeff
Thanks Jeff. I'll put that on the web site.
Paul Lamar
Hi!: I've always had a curiosity about the possible results of a Peripheral Intake
Port plus Side Exhaust Ports RCE, and as it seems that you have an actual or real
experience with such arrangement, please, if possible, I'd greatly appreciate
somebody communicating the results with this kind of rotary engine, PP intake
+ Side Exhaust Port, and if data refer to engines with only the Peripheral
Intake Port, or if the initial side intake ports are maintained, thus making a
mixed peripheral plus side intake porting and side exhaust porting.
Many thanks for your attention. Have a nice week, best regards, salut +
Jose Gros-Aymerich
E-28033 Madrid, Spain
We never tried both P-port and side intake but Richard Sohn said it was not worth it for aircraft use. Aixro uses both
for thier go cart engine.
The p-port intake and side exhaust works extremely well with an idle
as good as a 13B engine with side intake and peripheral exhaust.
We get 250 HP at 7500 RPM.
Over 70,000 people have viewed our You Tube video on the subject.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.