Gang, I need a couple used clutch disks that fit the input shaft of a
 manual transmission.

 If you have a couple you do not need, shout at me. milo

 Think I have a 1993 disc you can have. It has rubber dampers, 9.5" OD
 and rust.

 Robert

 Milo,
 Clutch discs from what vehicle ??..............There are many input
 shaft sizes (diameters and spline numbers) and spring sizes (for
 different torque input) available..........The "ROSS"
 PSRU's used one that might be suitable............Paul may know what
 "ROSS" used........

 Kelly Troyer

 1 inch

 Paul Lamar


 Kelly,
 I need a couple example clutch disks from RX 7, and RX 8 standard
 manual transmissions, I think they are both the same physical dimension.

 As a matter of fact I need a couple input transmission shafts for the
 manual transmissions as well, if any one might have them, and do not
 plan on using them.

 I am waiting for a response from Robert so that I can send him
 shipping money, if anyone knows his address contact me as below. I
 particularly want one with the rubber dampers.

 Thanks gang! milo


Hey Milo;
IIRC, There are many RX7 clutch dimensions -
215/225/230/236/240mm...look at Mazdatrix/Racing Beat/aftermarket and
racing 5.5/7.25"
rx7club.com is a good source for used parts and information.
What are you trying to do?
Cheers
Cary

The OD matters not for our purposes of connecting the GB to the flex plate. It is the input shaft spline that is important. For cars it is pretty close
to being standardized.

Paul Lamar