Paul, crank shaft finally arrived.

 I need guidance on how to trim this, and specific dimension for the plug that goes on the end of the crankshaft, length
 of the shaft, to support the thrust needle bearings, needle bearing part numbers, etc.

 I would like to plan for the simplest and lightest drive combination using the attached methods for the first shot, have
 another crankshaft piece in bound for the second shot.

 Milo

 ROBERT speak to me, I need that clutch plate NOW. Any body know Robert help me contact him.

Milo,
I thiink I have laying around. I will check and get back to you.
Dale in Beaumont, TX

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.