Subject: Dissolving Castor Oil gum/varnish/carbon
From: AAA-rotaryeng
Date: 2/8/2013, 8:54 AM
To: AAA-rotaryeng


 I was using Blendzall's Racing Castor premix in my rotary, guess it was a bad idea, it seems ALL the apex seals are
 stuck solid due to gum/varnish build-up!! NO! HELP! Anyone know of anything I might be able to squirt inside it to
 dissolve that gunk and save me from a pull & rebuild?! THX!

Dan Gorsline

Try ATF for a few days.


If it is a 13B.
Then use a 1/4 inch dowel to work the seals in and out in their slots  through the exhaust ports.

If it is an RX8 you are stuck :)

Once it is running again pour some water in the intake to blow out the carbon.
Not enough to kill it. Keep it running while doing so.

Use only 2 cycle oil premix in the future.

Paul Lamar
--

Dan, Being a model airplane addict that uses castor oil for lubricant, have seen this castor varnish many times in my older engines. The only thing I have ever found to clear this gunk out is more model airplane fuel. That would be methanol, nitro methane , and castor. 10% nitro should be sufficient. Fuel with synthetic oil will work better also to clean, and not rust everything together.

Bob Mears


ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.