Subject: Alu Water pump & test stand
From: AAA-rotaryeng
Date: 2/9/2013, 10:35 PM
To: AAA-rotaryeng


Hi Paul & All,
Getting the 13b single rotor ready to run,
Am in the process of fabricating a test stand,


Q1. Do you have drawing for various engine mount bolt holes for the Vans series. I plan to run the 20b on the stand with RV10 mount after 13b runs are completed.


I'm following Richard Sohn's lead with Hirth gearbox on the 13b single rotor, I have the G50, 2.58.

Q2. Richard any comments on your Hirth now that your flying it?


I bought an Alu. water pump p/n gmb 145-1180, has casting gmb mz18, note end stud hole absent?

Q3. Will the prop centerline offset of 3 1/4 in. have a significant effect on E-shaft C/L torque measurement?


Best Regards,
Rolland savoie
Flock of KitFoxes
20b, 12a & 13b single rotors


Q1. This is the RV10 with the old bottom rear mount and Schertz beam.
The top mout and Jeff's plate would simplify things.

Q3. I am not sure what you mean here. Can you sent a sketch?

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.