Subject: Dissolving Castor Oil gum/varnish/carbon
From: AAA-rotaryeng
Date: 2/9/2013, 3:46 PM
To: AAA-rotaryeng


 I was using Blendzall's Racing Castor premix in my rotary, guess it was a
 bad idea, it seems ALL the apex seals are
 stuck solid due to gum/varnish build-up!! NO! HELP! Anyone know of
 anything I might be able to squirt inside it to
 dissolve that gunk and save me from a pull & rebuild?! THX!

 Dan Gorsline

 Try ATF for a few days.


 If it is a 13B.
 Then use a 1/4 inch dowel to work the seals in and out in their slots
 through the exhaust ports.

 If it is an RX8 you are stuck :)

 Once it is running again pour some water in the intake to blow out the
 carbon.
 Not enough to kill it. Keep it running while doing so.

 Use only 2 cycle oil premix in the future.

 Paul Lamar
 --

 Dan, Being a model airplane addict that uses castor oil for lubricant, have
 seen this castor varnish many times in my older engines. The only thing I
 have ever found to clear this gunk out is more model airplane fuel. That
 would be methanol, nitro methane , and castor. 10% nitro should be
 sufficient. Fuel with synthetic oil will work better also to clean, and not
 rust everything together.

 Bob Mears

 Yes, Paul is correct (as always) I too know of the water trick to remove carbon build-up. Good to remove carbon
 build-up that causes pre-ignition in reciprocating engines. Give it a go, if it is running! shock cooling the carbon
 will dislodge it and spit it out the exhaust. What do you think about throttle body cleaner Paul, I think it could work
 too and support combustion?


 I have no experience with that.

 Paul Lamar

Thx everyone! Keep the ideas coming!
I've tried the ATF trick hasn't worked so far (although I did NOT let it sit for a few days...just over-night-gotta let
it sit longer I guess), tried throttle-body/carb cleaners (over-night), foaming engine degreaser...(same). This castor
varnish seems to be pretty hard-core.. Time to do it again!

Dan G.

Do you have the exhaust manifold off?

If you can spin it fast enough it will start with leaking apex seals.
Like coasting down a steep hill in high gear. Or towing it in high
gear.

Once it is hot and running then use the water in the intake trick.

Paul Lamar

 The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2013 All world wide rights reserved.