I was using Blendzall's Racing Castor premix in my rotary, guess it
was a
bad idea, it seems ALL the apex seals are
stuck solid due to gum/varnish build-up!! NO! HELP! Anyone know of
anything I might be able to squirt inside it to
dissolve that gunk and save me from a pull & rebuild?! THX!
Dan Gorsline
Try ATF for a few days.
If it is a 13B.
Then use a 1/4 inch dowel to work the seals in and out in their slots
through the exhaust ports.
If it is an RX8 you are stuck :)
Once it is running again pour some water in the intake to blow out the
carbon.
Not enough to kill it. Keep it running while doing so.
Use only 2 cycle oil premix in the future.
Paul Lamar
--
Dan, Being a model airplane addict that uses castor oil for
lubricant, have
seen this castor varnish many times in my older engines. The only
thing I
have ever found to clear this gunk out is more model airplane fuel.
That
would be methanol, nitro methane , and castor. 10% nitro should be
sufficient. Fuel with synthetic oil will work better also to clean,
and not
rust everything together.
Bob Mears
Yes, Paul is correct (as always) I too know of the water trick to
remove carbon build-up. Good to remove carbon
build-up that causes pre-ignition in reciprocating engines. Give it
a go, if it is running! shock cooling the carbon
will dislodge it and spit it out the exhaust. What do you think
about throttle body cleaner Paul, I think it could work
too and support combustion?
I have no experience with that.
Paul Lamar
Thx everyone! Keep the ideas coming!
I've tried the ATF trick hasn't worked so far (although I did NOT let
it sit for a few days...just over-night-gotta let
it sit longer I guess), tried throttle-body/carb cleaners
(over-night), foaming engine degreaser...(same). This castor
varnish seems to be pretty hard-core.. Time to do it again!
Dan G.
Do you have the exhaust manifold off?
If you can spin it fast enough it will start with leaking apex seals.
Like coasting down a steep hill in high gear. Or towing it in high
gear.
Once it is hot and running then use the water in the intake trick.
Paul Lamar
I use carb/choke cleaner to clean throttle body. But that stuff can be
too strong for some of the components in rare cases. The newer cars have
a small hole build into the throttle plate, so throttle body cleaning
may be as out dated as points and condensors.
Tony Lam
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.