Hi Paul & All,
Getting the 13b single rotor ready to run,
Am in the process of fabricating a test stand,
Q1. Do you have drawing for various engine mount bolt holes for the Vans
series. I plan to run the 20b on the stand with
RV10 mount after 13b runs are completed.
I'm following Richard Sohn's lead with Hirth gearbox on the 13b single
rotor, I have the G50, 2.58.
Q2. Richard any comments on your Hirth now that your flying it?
I bought an Alu. water pump p/n gmb 145-1180, has casting gmb mz18, note
end stud hole absent?
Q3. Will the prop centerline offset of 3 1/4 in. have a significant
effect on E-shaft C/L torque measurement?
Best Regards,
Rolland savoie
Flock of KitFoxes
20b, 12a & 13b single rotors
Q1. This is the RV10 with the old bottom rear mount and Schertz beam.
The top mount and Jeff's plate would simplify things.
Q3. I am not sure what you mean here. Can you sent a sketch?
Paul Lamar
The torque measurement is based on the distance between the fixed mount,
on one side of the engine, and the attachment point of the hydraulic
cylinder, on the other side of the engine, not on the distance from the
C/L of the shaft to the attachment point of the hydraulic cylinder.
Look at the Un-Symetrical-motor-mount-side-rad-TV2.jpg attachment on
Paul's email. If the torque applied at the shaft is 100 Ft/Lb the
reactive load at the right side mount is:
((8.21+14.78)/12)*100.
It is not:
(14.78/12)*100
The vertical distance between the shaft C/L and the line connecting the
two mount points has no effect on the reaction at the mount point.
Mark LaPierre