This prevents the core from being crushed when the motor mounting
bolts are torqued down.
It is made from aluminum so it must be etched or the epoxy will not
stick to it.
You can get this etch stuff at yacht stores.
This is for a 1/4 inch thick panel.
When building the panel from scratch
I would use a 3/4 inch long (assuming a 3/4 inch thick panel) section of 1.5 inch diameter round wood dowel commonly
known as "hand rail" or closet hanger pole in home depot. Much cheaper than this device. You just cut a 1.5 inch hole in
the core and replace it with the wood.
Here is an illustration from Zekes book Advanced Composite Techniques. Zeke used aluminum but that is a bit over kill
and a bit heavier than need be. End grain pine is fine. Epoxy sticks to pine fine no need to etch.
If you use plywood for the core this is unnecessary but a bit heavier than foam.
Most of the foam cores do not have sufficient compressive strength to handle
bolts directly.
Paul Lamar