Paul,
Some pictures of a tight cowling. No word yet on how well (or not) it will cool. I'm fairly confident about the water
cooling, but the oil cooling intake, I think, is questionable. Will tie the plane down outside and begin testing in
earnest as soon as I can dig it out of the shop.
Replaced a lot of parts (almost all!) during the rebuild. Wondering if any in the group would care for the leftovers.
Chris Cosman lives nearby... Most parts are about 1986 13b, some earlier. The rotor and housings are nearly perfect
for wear. Jeff began machining the peripheral housing for a P port, only to learn that its through bolt spacing is
different, and will not allow for a 2 in intake. It could be made smaller, however. I have all the 3mm seals and
springs for the rotor. Look at the pictures, make an offer and get it out of here.
Lewis Bjork
You need to replace that black rubber hose with aluminum tubing or silicon hose and constant tension hose clamps. I hope
there is beedings on the fittings where the hose is clamped to. The pressure can build to 30 psi or more in the cooling
system and that 50 pound force can jerk the hose off with disastrous over heating. I hate to see you waste all your time
and money for saving a few bucks on the cooling plumbing. Not to mentions getting hurt or worse.
Do you have my cooling book? If not contact me by saying private and I will get you a bargain price.
Paul Lamar
Lewis,
What part numbers on the needle thrust bearings in that plastic bag.
Paul, how is the design coming?
Milo
I am done. I will leave the input end up to you.
Where do you want me to ship the Lyc shaft?
Paul Lamar
Paul
Could you send me the Lycoming shaft dimension as references.
I miss you on your last Florida trip
Thanks
Jean
I am hard at work on these motor mounts as they are going to be about
33% of the cost of existing motor mounts. I had to get back to Cal
as south Florida was too much to drive to on that trip. Alex was about even
with Ocala.
Robin talked me into going to sun n fun and take a free tig welding
aluminum course in the Lincoln tent. She has a gig on the radio station
each year. Perhaps I will see you there.
The shaft is 2 and 3/8th inch in diameter and the plain bearing length is 4.9
inches long. The oil slinger ring is .4 inches wide. Then there is a front oil
seal length of about 1.5 inches long. Next comes the standard CS prop flange
or a standard 6 in dia wood prop flange.
Its fairly heavy at 3.9 pounds. Wood prop flange.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.