Subject: Cowling and loose parts
From: AAA-rotaryeng
Date: 3/2/2013, 12:09 PM
To: AAA-rotaryeng


Paul,
Some pictures of a tight cowling. No word yet on how well (or not) it will cool. I'm fairly confident about the
water cooling, but the oil cooling intake, I think, is questionable. Will tie the plane down outside and begin
testing in earnest as soon as I can dig it out of the shop.


Replaced a lot of parts (almost all!) during the rebuild. Wondering if any in the group would care for the
leftovers. Chris Cosman lives nearby... Most parts are about 1986 13b, some earlier. The rotor and housings are
nearly perfect for wear. Jeff began machining the peripheral housing for a P port, only to learn that its through
bolt spacing is different, and will not allow for a 2 in intake. It could be made smaller, however. I have all the
3mm seals and springs for the rotor. Look at the pictures, make an offer and get it out of here.


Lewis Bjork

You need to replace that black rubber hose with aluminum tubing or silicon
hose and constant tension hose clamps. I hope there is beedings on the fittings
where the hose is clamped to. The pressure can build to 30 psi or more
in the cooling system and that 50 pound force can jerk the hose off with disastrous over heating. I hate to see you
waste all your time and money for saving a few bucks on the cooling plumbing. Not to mentions getting hurt or worse.


Do you have my cooling book? If not contact me by saying private and I will get you a bargain price.

Paul Lamar

Lewis

What is the size of P port that can be fitted ? Are these non turbo housings? What is your asking price for the rotor
housings?

Robert LeClercq


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.