I got the hub back today Paul.

 When will the dimension drawings be available?

 Tell Frank I will spring for the $250 if you will handle the sales

 Milo

 Jim Rudholm found some heat sink surplus and much cheaper. I called them and they have 175 in stock. The size is enough for 3 heat sinks. The cost  for 3 would be  $25.

 Here are the PSRU dwgs.

 It would be better if I sent you an IGES or DXF.
 What dwg program are you using? The dims are in the IGES or DXF files.

 Paul Lamar

 Paul, is that the sum total of the dimensions?. Milo

What else do you need? Use the planet carrier and a transfer punch to get the hole pattern for that.

Do you have a lycoming shell bearing yet?

Paul Lamar


Justs checking. Did not want to run afoul of your expectations.'
Do not have a shell bearing yet, but will get one.
If you have a used one around that you are not using, I would like to use it for fitting up. milo


--
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas Copyright 1998-2013 All world wide rights reserved.