Subject: Bent turbo shaft
From: rotary engine
Date: 3/9/2013, 7:31 AM
To: AAA-rotaryeng
CC: Jim Mederer <jimmederer@yahoo.com>

Jim Mederer is doing some durability testing on after market apex seals on his dyno. This is what happened after about one hour at 5 psi boost.

Apparently the shaft in a TO4 is larger as this has not been reported so far with the TO4 shafts. Dave Leonard has a stock turbo but the shaft has been upgraded to a TO4.... I think.

The part number on the turbo is PEMO 3059 706451-5005S

Jim thinks it happened while the turbo was rotating but I suspect it happened in heat soak. Normally our modes of failure is the blades are thrown off.

Paul Lamar

-- 
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.