Jim Mederer is doing some durability testing on after market apex seals
on his dyno. This is what happened after about one hour at 5 psi boost.
Apparently the shaft in a TO4 is larger as this has not been reported so
far with the TO4 shafts. Dave Leonard has a stock turbo but the shaft
has been upgraded to a TO4.... I think.
The part number on the turbo is PEMO 3059 706451-5005S
Jim thinks it happened while the turbo was rotating but I suspect it
happened in heat soak. Normally our modes of failure is the blades are
thrown off.
Paul Lamar
I looked at the image and have only one comment.
This is the most common type of damage I have seen on turbines discarded
during the eco-boost developement testing.
To clarify, it is the chiping of the blades, not shaft bending.
C. Smith
What brand and model number Craig?
Paul Lamar