Subject: Bent turbo shaft
From: rotary engine
Date: 3/12/2013, 5:10 PM
To: AAA-rotaryeng


Jim Mederer is doing some durability testing on after market apex seals on his dyno. This is what happened after about one hour at 5 psi boost.

Apparently the shaft in a TO4 is larger as this has not been reported so far with the TO4 shafts. Dave Leonard has a stock turbo but the shaft has been upgraded to a TO4.... I think.

The part number on the turbo is PEMO 3059 706451-5005S

Jim thinks it happened while the turbo was rotating but I suspect it happened in heat soak. Normally our modes of failure is the blades are thrown off.

Paul Lamar


I looked at the image and have only one comment.
This is the most common type of damage I have seen on turbines discarded during the eco-boost developement testing.

To clarify, it is the chiping of the blades, not shaft bending.

C. Smith

What brand and model number Craig?

Paul Lamar

Sorry, it's been almost two years. They were all the same manufacturer, but I don't remember the name off the top of my head. I do remember seeing the same thing over and over again, on the scrap carts though.
C. Smith



-- 
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.