I never saw any comment on my earlier query about the best place/way to get
an engine. Do you have any personal comments on that? Thanks.
Finally I saw your recent post about a robot welder for a universal engine
mount. I am curious about the design - have you sent out prior messages
with more information that I may have missed before joining the list?
Jame Osbourn
I suggested a couple of places. Are you saving your email?
There are a bunch of email programs out there so it is hard to give
advice about how to file them by subject.
I have been using Thunderbird for 15 years.
The universal low cost motor mount is one third the cost of the
traditional welded tube motor mount. It uses rod end jointed links to
support the engine. Used by Bristol aircraft radial engines in WW II.
It will fit almost any firewall bolt pattern. Check out the end of the
first page on
http://www.rotaryeng.net for prices on some of the
required bits.
We had a guy building good motor mounts but he retired. Typically they
cost $1500. The trouble is no two motor mounts are exactly the same for
the wide range of rotary powered aircraft. Cutting and fitting tubes is
an art. It can be done by a laser cutter but that is expensive and still
requires a custom welding jig and welding.
Paul Lamar