Subject: early slide throttle pictures
From: rotary engine
Date: 3/17/2013, 9:29 AM
To: AAA-rotaryeng



This engine won many 24 hour races before the rotary was
heavily handicapped.


Paul Lamar


I would buy injector blocks like those, seats unmachined so
the end user could finish then to suit their own injectors.
Anyone else interested? Jeff?
C. Smith

Mechanical injection ?

Paul Lamar

I'm talking about the design of the piece that holds the injectors,
the seats radialy centered on the intake tube not talking about
using mechanical injection.
C. Smith

What is the matter with this design? It was done this way to simplify the fuel rail. You need a minimum of two injectors per p-port runner to get fine control over the amount of fuel injected over the power and RPM range. The RX8 engine uses three per rotor.

Some of the fuel may impinges on the side wall but it evaporates eventually and is not lost. The vapor eventually goes in the engine.

Matter can neither be created nor destroyed. It is a law of physics.
It is just not a good idea. IT IS THE LAW! :)

http://en.wikipedia.org/wiki/Conservation_of_energy

To "crack" gasoline into other constituent molecules takes a lot of heat. The intake  manifold usually runs ice cold due to evaporation.

Paul Lamar


I didn't say anything was the matter with your design. I like the other one better. No fuel rail at all, how simple is that?. Since I'm not using the narrow injectors you designed it for, I was going to use components from Kinsler, and plumb it similar to the early slide throttle image you posted. Saves having to weld up a fuel rail, individual injectors can be removed without disturbing the rest of them, etc.
C. Smith

How do you attach the fuel hose to the standard injectors?

Can you get a screen shot from the Kinsler catalog?

Paul
-- 
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.