Subject: early slide throttle pictures
From: rotary engine
Date: 3/17/2013, 12:20 PM
To: AAA-rotaryeng


This engine won many 24 hour races before the rotary was
heavily handicapped.


Paul Lamar


I would buy injector blocks like those, seats unmachined so
the end user could finish then to suit their own injectors.
Anyone else interested? Jeff?
C. Smith

Mechanical injection ?

Paul Lamar

I'm talking about the design of the piece that holds the injectors,
the seats radialy centered on the intake tube not talking about
using mechanical injection.
C. Smith

What is the matter with this design? It was done this way to simplify
the fuel rail. You need a minimum of two injectors per p-port runner to
get fine control over the amount of fuel injected over the power and RPM
range. The RX8 engine uses three per rotor.

Some of the fuel may impinges on the side wall but it evaporates
eventually and is not lost. The vapor eventually goes in the engine.

Matter can neither be created nor destroyed. It is a law of physics.
It is just not a good idea. IT IS THE LAW! :)

http://en.wikipedia.org/wiki/Conservation_of_energy

To "crack" gasoline into other constituent molecules takes a lot of
heat. The intake  manifold usually runs ice cold due to evaporation.

Paul Lamar


I didn't say anything was the matter with your design. I like the other
one better. No fuel rail at all, how simple is that?. Since I'm not
using the narrow injectors you designed it for, I was going to use
components from Kinsler, and plumb it similar to the early slide
throttle image you posted. Saves having to weld up a fuel rail,
individual injectors can be removed without disturbing the rest of them,
etc.
C. Smith

How do you attach the fuel hose to the standard injectors?

Can you get a screen shot from the Kinsler catalog?

Paul


Is this what you have in mind?

Notice there is no groove for the retention clip on the RX8 or Siemans skinny injectors.

Most people now use the skinny injectors. The fat GM injectors are more or less obsolete.

We have spent a lot of thought on this subject over the past 15 years :)

I would love to have a injector that you could just screw on a hose fitting. It would allow much more flexibility in where exactly injectors were mounted.

It might be possible to cut a grove in the plastic RX8 injectors but one would risk a failure with the hose coming off and the high pressure fuel squirting everywhere.

Paul Lamar

I have Ford racing injectors.
Pictures somewhere, but can't locate them.
C. Smith




-- 
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.