This engine won many 24 hour races before the rotary was
heavily handicapped.
Paul Lamar
I would buy injector blocks like those, seats unmachined so
the end user could finish then to suit their own injectors.
Anyone else interested? Jeff?
C. Smith
Mechanical injection ?
Paul Lamar
I'm talking about the design of the piece that holds the injectors,
the seats radialy centered on the intake tube not talking about
using mechanical injection.
C. Smith
What is the matter with this design? It was done this way to simplify
the fuel rail. You need a minimum of two injectors per p-port runner to
get fine control over the amount of fuel injected over the power and RPM
range. The RX8 engine uses three per rotor.
Some of the fuel may impinges on the side wall but it evaporates
eventually and is not lost. The vapor eventually goes in the engine.
Matter can neither be created nor destroyed. It is a law of physics.
It is just not a good idea. IT IS THE LAW! :)
http://en.wikipedia.org/wiki/Conservation_of_energy
To "crack" gasoline into other constituent molecules takes a lot of
heat. The intake manifold usually runs ice cold due to evaporation.
Paul Lamar
I didn't say anything was the matter with your design. I like the other
one better. No fuel rail at all, how simple is that?. Since I'm not
using the narrow injectors you designed it for, I was going to use
components from Kinsler, and plumb it similar to the early slide
throttle image you posted. Saves having to weld up a fuel rail,
individual injectors can be removed without disturbing the rest of them,
etc.
C. Smith
How do you attach the fuel hose to the standard injectors?
Can you get a screen shot from the Kinsler catalog?
Paul
Not sure how to take a screen shot. However, page 140 of catalog #32
part No. 10396, or 10397, or page 143 PN/ 10382 (requires the boss type
found on page 161 lwr left).
C. Smith
That is the fat GM injectors. Rarely used now. Most people use the
skinny RX8 or Seimans injectors.
To take a screen shot press the Prt Scr key on the keyboard.
That puts a picture in the clip board.
Load MS Paint and select paste.
Save the file as a jpg.
We could do something like this at great expense.
How important is it for you to have one hose for each injector?
You are going to go through a lot of AN Tee fittings :)
Paul Lamar