I was reading the SDS EFI web site and notice they don't offer rotary ignition support.

This is just an idea at this stage.

A simple ignition system using RX8 coils with a 2.5 ms
dwell time has a problem.

   7000 RPM is   116.7 rev per second or 42,000 degrees per
    second  or one e-shaft degree in .02 ms.

1 ms is 1/1000 of a second.

So the ignition will be retarded 42,000 / 2.500 or
16.8 degrees. What is needed is advance at high RPM.

In the old days that was done by a distributor with mechanical and
vac advance.

That is for a real simple system that fires when the
CAS sends a trigger to the coil. A computer can fix this
but there may be a simpler way.


Hall Effect sensors are cheap and several can be used.
Lets say we have 4. The first one is used for 0 to 2000 RPM.
A small magnet would be mounted on the e-shaft pulley.

#1 0 to 2000 RPM 0 advance for good starting.
#2 2000 to 4000  14 degrees
#3 4000 to 6000  22 degrees
#4 6000 to 8000. 33 degrees

There is a device called called a data selector.
It is just a black box that can select one of these
HE sensors depending on RPM. Or the pilot can select one.

The black box can be controlled by a computer or an
analog to digital converter chip.

These charts are for cars but we have used a fixed advance
22 degrees BTC with good results.
If you set it at a greater number to compensate for the
coil 2.5 ms dwell that means you would have 16.8 +_22 which
might cause starting problems.

Just thinking out loud here.

Paul Lamar