Subject: Robo welder is rotating VERY FIRST WELD
From: rotaryeng
Date: 3/28/2013, 7:33 PM
To: AAA-rotaryeng








      This was a wild ass guess on current (80
 amps), gas flow
  (12.5 CFH) and tungsten
  distance (about 1/8 inch).
   The 60 Cycle synchronous gear motor was rotating at 1
 RPM.
  You can set your watch on it.
   I am going to have a party tonight :)
   This is as close to a perfect weld as it gets.
   The last picture was some welding done by the best
 welder I
  know. He is a guy that works for
  George Talbot Talins company in Torrance Ca.
   Paul Lamar

  That looks very good. Is that autogeneous welding or
 are you
  using filler?
  You might make the taper a tad longer on the electrode.
  Typicly 2 to 1-1/2
  electrode diameter. What is the make/model of your welder
  power source?
  C. Smith

    Thanks for the tip (pun unintended) :)
   I'll try that.
   Do you know of a hand held device that one can put a
 length
  of tungsten electrode in and have it rotate it while you
  are grinding the tip? In theory the tip would come out
  perfectly
  symmetrical.
   What is  autogeneous welding ?
   No filler rod.
   Lincoln square wave tig 175 pro.
   Paul Lamar

   Just one other note. I see in the image you have the
 grounding wires looped
 around the workpiece. In general this is not recommended
 practice, because
 you have effectively created an iron core inductor. This
 will resist the
 flow of current (causing you to use a setting higher than
 necessary), it
 also will add to the heat in your ground circuit. When you
 get into
 "production" this may lead to your ground wires getting hot.
 Avoid loops in
 welding circuits.
 C. Smith
  It has had no affect I can detect so far.
  Still one long line.
  BTW I got the money for the oil pan. Thanks.
  If some of you have not sent in your deposit for the oil pan
 on this go
 around the price will go up.
  Paul Lamar

I just thought about it again, you are welding carbon
steel, DC welding. No inductive effects. I'm used to AC
welding currents in resistance welding and aluminum. Sorry.
C. Smith




Paul,
  What are your rod end adapters machined from ??
-- 
Kelly Troyer
Dyke Delta_"Eventually"
13B_RD1C_EC2_EM2

Mild steel. They are very lightly stressed in this application.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.