Subject: Robo welder is rotating VERY FIRST WELD
From: rotaryeng
Date: 3/28/2013, 9:04 PM
To: AAA-rotaryeng





    

    

    

    

    




________________________________

 
       This was a wild ass guess on current (80
  amps), gas flow
   (12.5 CFH) and tungsten
   distance (about 1/8 inch).
    The 60 Cycle synchronous gear motor was rotating at 1
  RPM.
   You can set your watch on it.
    I am going to have a party tonight :)
    This is as close to a perfect weld as it gets.
    The last picture was some welding done by the best
  welder I
   know. He is a guy that works for
   George Talbot Talins company in Torrance Ca.
    Paul Lamar

   That looks very good. Is that autogeneous welding or
  are you
   using filler?
   You might make the taper a tad longer on the electrode.
   Typicly 2 to 1-1/2
   electrode diameter. What is the make/model of your welder
   power source?
   C. Smith

     Thanks for the tip (pun unintended) :)
    I'll try that.
    Do you know of a hand held device that one can put a
  length
   of tungsten electrode in and have it rotate it while you
   are grinding the tip? In theory the tip would come out
   perfectly
   symmetrical.
    What is  autogeneous welding ?
    No filler rod.
    Lincoln square wave tig 175 pro.
    Paul Lamar

    Just one other note. I see in the image you have the
  grounding wires looped
  around the workpiece. In general this is not recommended
  practice, because
  you have effectively created an iron core inductor. This
  will resist the
  flow of current (causing you to use a setting higher than
  necessary), it
  also will add to the heat in your ground circuit. When you
  get into
  "production" this may lead to your ground wires getting hot.
  Avoid loops in
  welding circuits.
  C. Smith
   It has had no affect I can detect so far.
   Still one long line.
   BTW I got the money for the oil pan. Thanks.
   If some of you have not sent in your deposit for the oil pan
  on this go
  around the price will go up.
   Paul Lamar

I just thought about it again, you are welding carbon
steel, DC welding. No inductive effects. I'm used to AC
welding currents in resistance welding and aluminum. Sorry.
C. Smith


Paul,
   What are your rod end adapters machined from ??
-- Kelly Troyer
Dyke Delta_"Eventually"
13B_RD1C_EC2_EM2

Mild steel. They are very lightly stressed in this application.

Paul Lamar

Were they adapted from something that was already threaded and
what thread size are you using ??....(I probably missed that info)

Kelly Troyer


They were machined on an NC lathe from hex bar stock.
Ten are required for a universal motor mount.

7/16  20.

This carbon-fiber/Teflon lined rod end screws into the adapter.
Look at the bottom of the web site front page where items for sale
are shown.  http://www.rotaryeng.net

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2013 All world wide rights reserved.