Subject: Robo welder is rotating VERY FIRST WELD
From: rotaryeng
Date: 3/29/2013, 4:12 AM
To: AAA-rotaryeng


 This was a wild ass guess on current (80
amps), gas flow  (12.5 CFH) and tungsten  distance (about 1/8 inch).The 60
Cycle synchronous gear motor was rotating at 1 RPM.  You can set your watch
on it.I am going to have a party tonight :)This is as close to a perfect
weld as it gets.The last picture was some welding done by the best welder I
know. He is a guy that works for  George Talbot Talins company in Torrance
Ca.

Paul Lamar


That looks very good. Is that autogeneous welding or are you
using filler?  You might make the taper a tad longer on the electrode.
Typicly 2 to 1-1/2  electrode diameter. What is the make/model of your
welder  power source?

C. Smith


Thanks for the tip (pun unintended) :)I'll
try that.Do you know of a hand held device that one can put a length  of
tungsten electrode in and have it rotate it while you  are grinding the tip?
In theory the tip would come out  perfectly  symmetrical.What is
autogeneous welding ?No filler rod.Lincoln square wave tig 175 pro.

Paul Lamar


Just one other note. I see in the image you have the grounding wires
looped around the workpiece. In general this is not recommended practice,
because you have effectively created an iron core inductor. This will resist
the flow of current (causing you to use a setting higher than necessary), it
also will add to the heat in your ground circuit. When you get into
"production" this may lead to your ground wires getting hot. Avoid loops in
welding circuits.

C. Smith

It has had no affect I can detect so far.  Still
one long line.

BTW I got the money for the oil pan. Thanks.  If some of you
have not sent in your deposit for the oil pan on this go around the price
will go up.

Paul Lamar

I just thought about it again, you are welding
carbonsteel, DC welding. No inductive effects. I'm used to ACwelding
currents in resistance welding and aluminum. Sorry.

C. Smith

Paul,  What are
your rod end adapters machined from ??
--
Kelly Troyer
Dyke Delta_"Eventually"
13B_RD1C_EC2_EM2

Mild steel. They are very lightly stressed in this
application.

Paul Lamar

Paul,  I wondered if you have seen the commercially available orbital
welders from companies like Swaglok. They have been doing tubing welders
for years. They probably would be much more expensive though

Bill Jepson

No but it makes sense for somebody to sell stuff like that.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.