One must make a fixture to hold the rubber bushing mounts in alignment.
It
consist of a 1.5 inch square 1/8 th wall square tube with holes for the
1/2
inch bolts. The bolt holes are 21.5 inches apart. Drill on a drill
press
so the holes are vertical.
The captions on the photos explain some other points.
It is best to set it up in the corner of a room so you can get some
horizontal measurement for the center of the prop flange. Sort of a 3
dimensional square.
The bottom line is; the prop flange must come out in the center of the
cowling hole. It is very time consuming to modify or make a new cowl.
This mount allows you to adjust for that.
BTW use AN bolts. These hard ware store bolts are just for initial
set up. Paul Lamar
Looks impressive Paul,
Alex
It is very ridged. With the Teflon rod ends there is NO looseness at all.
ZILCH... NADA ....:)
Wait till use see the RX8 P-port engine I have mounted :) I should have
that done today. Waiting for a set of rubber bushings from Mc Master car.
===============================================================
Order Date
3/29/13<
http://www.mcmaster.com/#order-history/0329WLAMAR
Ordered By Lamar McMaster-Carr Number 1174050
Line Product Ordered Ships Price Total
1 6309K34<
http://www.mcmaster.com/nav/enter.asp?partnum=6309K34
Versa-Mount
Vibration-Damping Mount, 130 lb Compression Capacity, 1.94" H Overall 2
each today
(from our Chicago warehouse)
8.30
each 16.60
2 6309K35<
http://www.mcmaster.com/nav/enter.asp?partnum=6309K35
Versa-Mount
Vibration-Damping Mount, 240 lb Compression Capacity, 1.94" H Overall 2
each 2 weeks
8.30
each 16.60
3 57145K74<
http://www.mcmaster.com/nav/enter.asp?partnum=57145K74
==============================================================
We have two durometers to try. Soft and medium.
Paul Lamar
FYI... the heim joint locking/interference nuts might/ might not pass muster
with FAA/ DA inspector if they don't have a safety wire mechanism. I do NOT
recommend drilling a hole or castlation of the nut/ heim joint. Rather, I'd
recommend using a very wide washer, adjusting, then torquing the nut to
specification, then bending the overhanging flange of the washer flush onto
opposing sides of the nut. Then a small hole can be drilled in the washer
anywhere and thus used to safetywire to another place to indicate loss of
the nut's torque integrity.
Just my two cents worth.
Gary Buster
T25 East Texas
What is the problem with drilling safety wire holes in the nuts?
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.