This is a time to climb to 10,000 meters record attempt.
Time to climb is all about power to weight ratio and the Wankel
rotary
engine excels in that category.
Allan Tolle in a 300 HP Power Sport 2 rotor running on NOS and
100LL in an
RV3 holds the unofficial dead stop to 3000 feet record at just
under a minute.
Jim Mederer of Racing Beat fame is building the all
aluminum (200 pounds bare) 2 rotor p-port turbo charged 650 HP
engine.
Jim is a bit anal about rotor housing cooling hence the sprint car V8
water pump :) To my knowledge Jim never installed a "cylinder
head" temperature gage so this is based on a guess of what the
rotor housing temperature might be. The drag racers get many runs
out of such an engine.
This is also a tribute to the robust Mazda Wankel engine. In
street form the most HP Mazda every sold was 280 HP. 650 HP or
more is normal for drag racing. This engine will not use NOS but
it would be good for at least an additional 100 HP.
If one pumped up an aircraft piston engine to this level one
would have a
hand grenade in 15 seconds :)
The engine is being installed in an all ready flying Harmon
(REAL!) Rocket.
The gear box is a Bell 47 helicopter final drive. First used with
a rotary
back in 1973 by Dave Garber in his huff and puff Reno racer.
(Never got it to cool as that was long before my book on "How to
Cool Your
Wankel").
Taking off in a high power to weight ratio prop plane is challenging
to say the least. One must feed the power in slowly but not too
slowly
to get the record.
Russ McFarland, an expat American, living in New Castle
Australia, is sponsoring this project.
Now if I could only get him to sponsor a turbo compound rotary ....:)
Paul