Subject: wire feed for robo welder
From: rotaryeng
Date: 3/31/2013, 10:41 AM
To: AAA-rotaryeng


    

    

    

    




George, You will get a kick out of this.

This is my wire feeder. It is controlled by a 555 cost $1 pulse width
modulated
Pololu micro gear motor 1000:1  cost $23

Paul Lamar



Two engineering students were biking across a university campus when one
said, "Where did you get such a great bike?" The second engineer replied,
"Well, I was walking along yesterday, minding my own business, when a
beautiful woman rode up on this bike, threw it to the ground, took off all
her clothes and said, "Take what you want."  That's where I got the bike.
The first engineer nodded approvingly and said, "Good choice: The clothes
probably wouldn't have fit you anyway."

Joke curtsy of Leslie





Paul,  I think you need two more timers( a total of 3) when the trigger
goes on. The trigger would turn on the shield gas solenoid and start
the three timers. The first is an on delay to allow shield gas before
the wire feed starts, the second on  delay starts the wire feed motor
and closes a contactor for welding current, and the third is an off
delay which advances the wire slightly after welding so it won't burn
back in the tip for the next cycle.
      Google is at it again. They are trying to change the reply to a
message so that I can't add it after the current message. There is
a blank window for the reply. I temporarily disabled it but that won;t
last forever.
                         george

Thanks for the help.

Do you know of any low cost timers?

Does the foot pedal control the welding current directly or does it use a 12 volt
starter solenoid type device?

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.