Subject: wire feed for robo welder
From: rotaryeng
Date: 3/31/2013, 7:13 PM
To: AAA-rotaryeng









 George, You will get a kick out of this.

 This is my wire feeder. It is controlled by a 555 cost $1 pulse width
 modulated
 Pololu micro gear motor 1000:1  cost $23

 Paul Lamar



 Two engineering students were biking across a university campus when one
 said, "Where did you get such a great bike?" The second engineer replied,
 "Well, I was walking along yesterday, minding my own business, when a
 beautiful woman rode up on this bike, threw it to the ground, took off all
 her clothes and said, "Take what you want."  That's where I got the bike.
 The first engineer nodded approvingly and said, "Good choice: The clothes
 probably wouldn't have fit you anyway."

 Joke curtsy of Leslie

Paul,  I think you need two more timers( a total of 3) when the trigger
goes on. The trigger would turn on the shield gas solenoid and start
the three timers. The first is an on delay to allow shield gas before
the wire feed starts, the second on  delay starts the wire feed motor
 and closes a contactor for welding current, and the third is an off
 delay which advances the wire slightly after welding so it won't burn
back in the tip for the next cycle.
       Google is at it again. They are trying to change the reply to a
message so that I can't add it after the current message. There is
a blank window for the reply. I temporarily disabled it but that won;t
last forever.
                          george

Thanks for the help.

Do you know of any low cost timers?

Does the foot pedal control the welding current directly or does it use a
12 volt
starter solenoid type device?

Paul Lamar


Paul,  The brand I used was  " Idec".  They are solid state with the range
settable by toggles and  work as on delay, off delay, or interval. They
plug into a socket like used for a 3 contact glass relay. I use them as
part of a control system for automated machinery and light loads such as a
pneumatic valve or contactor coil. Probably rated 10 amps at 120 volt.
        I assume you are talking about the foot pedal control in a tig
welder. It varies the output voltage so it doesn't operate a starter
solenoid type contactor which is either on or off. Possibly it drains off a
pulse width modulator or something similar inside the welder. You can also
get a tig  torch head with a slider on the handle that does what the foot
pedal does which would indicate it is a small lightly loaded device. In use
it allows the voltage to be started high to establish the arc and melt a
puddle, then power is reduced for the welding. My Miller tig has an
autostart feature that does this and the foot pedal is used to modulate the
power during the welding.
                        george

Thanks George.

I'll talk to Lincoln about it at sun n fun.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.