I got it set up to where I think it will fit in the Tango cowling.
We shall see after Sun N Fun when I will be at the Tango factory
in Florida.

This is a p-port RX8 engine not quite mounted.

details ..details.. better in the next few days.

Paul Lamar



Paul, Do the mounting tubes have RH thread on one end and LH thread
on the other end or do you have to take the bolt out and turn the
rod ends?


george grimes.

That makes adjustment a bit easier.
I did not do that as it would up the cost for rod end adapters.
Twice the initial investment.

The down side is if a jam nut gets loose the tube can change
length from vibration. Worse case it can unscrew it self :)

Paul Lamar


Isn't that what lock wire is for?  I couple of strands on each tube
would keep them from "self adjusting" due to vibration.

-  Mark LaPierre


True.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.