This is the other half in charge of data acquisition.
MAP
mass air flow sensor
Intake air temperature
water temperature
oil temperature
water pressure
oil pressure
EGT rotor 1
EGT rotor 2
altitude pressure sensor
RPM
air speed
Up to 4 more.
It is a 16 channel analog to digital converter $15 chip that has been
around for 50 years. Still being made by TI. Tried and true.
The printer port sets up a 4 bit address for the channel and then
turns on ALE Address Latch Enable.
Then it tells the chip to Start the conversion.
Roughly 100 usecs later the chip signals the 2nd printer port
that it is
finished with the conversion. EOC In the meantime the computer has
been monitoring this pin. A technique called polling.
The printer port reads the data for that channel and then repeats the
process for all 16 channels.
This takes about 1.6 ms for all 16 channels.
The respones time for a MAP sensor is about 1 ms.
The program uses that data to calculate the injector pulse widths
and sends them out on the other printer port.
Not only is the VGA screen updated once a second but all the
parameters are
stored on the hard disk for future reference.
Paul Lamar