Subject: Cowling and loose parts
From: rotaryeng
Date: 5/3/2013, 5:41 AM
To: AAA-rotaryeng




What would happen if the p-port was moved away from the bolt hole a
bit to clear without interference. The power may be affected a bit
but the idle may be smoother by the fact of reduced overlap.



Dale Davies

Which bolt hole?

I don't really know. Not a lot of data on this subject.

This is all I have on various p-port parameters. I just copied the Le
Mans engine because I figured Mazda knew what they were doing ;)

Paul Lamar


G'day Dale, Xtreme rotaries who supply pports to the American market, make
pport housings for turbo and non turbo applications. The turbo units have
later inlet opening points for the extra inlet pressures of the compressed
intake charge., obviously to stop fuel being blow out the exhaust. What i
was wondering is" what if we used the non-turbo housings with a turbo and
fired the injectors after the exhaust has closed", this would give a cooler
pre compression charge allowing a higher comp. ratio similiar to the
skyactive tech. Do you catch my drift, purging of the chamber prior to
charging. Do you think this may allow leaner mixtures or higher boost (not
sure). anyway here's the link www.xtremerotaries.com  go to sevices then
peripheral porting. I think they supply to rec in Canada. this dude has
some time into rotary engineering.
Graeme Riley

Do extreme rotaries have any dyno curves showing the HP torque and BSFC?
I saw CFD movies on the flow simulation on the web site. Very impressive.
No doubt they flow a lot of air. BSFC is bottom line. The Mazda p-port is .47.
Do they have a dyno?

Paul Lamar


The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.