Subject: Voltage needed to jump the gap
From: rotaryeng
Date: 5/18/2013, 11:06 AM
To: AAA-rotaryeng




Still going through e-mails from while I could not access the net.

Also to be noted is that the required voltage to jump the gap on the cylinder
firing is a sum of resistances. Electrons and water are similar in that they
take the path of least resistance.

The resistance is a combination of the wire lead, the EMF suppression built
into the spark plug and the gap. Gap resistance is not as simple as "x"
resistance per .001" of gap. The air/fuel mixture is a resistor. Especially
the air molecules. As the air is compressed, more molecules are crammed in
the gap area creating higher resistance to the spark jumping the gap. This is
why supercharged engines typically use smaller plug gaps. The second plug in
a waste spark system contributes a minimal increase in the total resistance
as the amount of molecules in the gap at the end of the exhaust stroke and
the start of the intake is similar to ambient atmospheric and possibly less.
The major contributors to the spark voltage are the wire resistance coupled
to the firing cylinder gap.



Dale Davies


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.