Subject: motor cycle rear hub
From: rotaryeng
Date: 5/26/2013, 7:23 AM
To: AAA-rotaryeng

 Does anybody know about motor cycle rear hubs with rubber torque
 dampers?

 Make model and parts numbers.

 Paul Lamar

 Used on Honda 550/750 Bikes, Virg

 Thanks Virg

 Looks like the hot tip for a torque damper I think you need a wheel
 as well.

 Paul Lamar


 Paul,

 Maybe these would be easier to adapt to our use.  They're used in Mercedes,
 various models.  I would need one for a MB truck.  ;-)

 Mark

 We have already been down that road. They are too stiff. Also quite thick.
 where as the bike can only be 2 inches long or so.

 You can try it again however. The Rotamax was a small one rotor rotary.
 Run it on the ground for an hour or so and then inspect it after every
 flight for awhile.


 Paul Lamar

OK, here's one made by a R&D Drive Train Solutions for marine use... very
thin and could probably be bolted directly to the Mazda flex plate. Its
possible they have one that would mate to the RD2-C input shaft (yeah, I'm
dreaming.).

Mark

Where is the rubber?  I see angular mis alignment capabilities but no torsional
flexibility.

Paul Lamar


 The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
 http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2013 All world wide rights reserved.