Subject: motor cycle rear hub
From: rotaryeng
Date: 5/26/2013, 7:42 AM
To: AAA-rotaryeng


  Does anybody know about motor cycle rear hubs with rubber torque
  dampers?

  Make model and parts numbers.

  Paul Lamar

  Used on Honda 550/750 Bikes, Virg

  Thanks Virg

  Looks like the hot tip for a torque damper I think you need a wheel
  as well.

  Paul Lamar


  Paul,

  Maybe these would be easier to adapt to our use.  They're used
in Mercedes,
  various models.  I would need one for a MB truck.  ;-)

  Mark

  We have already been down that road. They are too stiff. Also
quite thick.
  where as the bike can only be 2 inches long or so.

  You can try it again however. The Rotamax was a small one rotor
rotary.
  Run it on the ground for an hour or so and then inspect it
after every
  flight for awhile.


  Paul Lamar

OK, here's one made by a R&D Drive Train Solutions for marine
use... very
thin and could probably be bolted directly to the Mazda flex
plate. Its
possible they have one that would mate to the RD2-C input shaft
(yeah, I'm
dreaming.).

Mark

Where is the rubber?  I see angular mis alignment capabilities
but no torsional
flexibility.

Paul Lamar


The best is make your own, AC Spruce has 4130 .090" thick sheet
18 by 18 for $36. Cut a flex plate to fit the 20B ring gear with a
plasma cutter. Weld up a motor cycle type torsional damper.
Use red silicon rubber. Good to 500 F. Make a mold out of Teflon.
Drill the rivets out Tracy's  spline flange and reuse that.

Make 2. I'll buy one for my 3 rotor TC project.

Paul Lamar

  The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
  http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
  Copyright 1998-2013 All world wide rights reserved.