Subject: motor cycle rear hub
From: rotaryeng
Date: 5/26/2013, 8:42 AM
To: AAA-rotaryeng



Does anybody know about motor cycle rear hubs with rubber torque
dampers?

Make model and parts numbers.

Paul Lamar

Used on Honda 550/750 Bikes, Virg

Thanks Virg

Looks like the hot tip for a torque damper I think you need a wheel
as well.

Paul Lamar


Paul,

Maybe these would be easier to adapt to our use. They're used in
Mercedes, various models. I would need one for a MB truck. ;-)

Mark

We have already been down that road. They are too stiff. Also quite
thick. where as the bike can only be 2 inches long or so.

You can try it again however. The Rotamax was a small one rotor
rotary. Run it on the ground for an hour or so and then inspect it
after every flight for awhile.


Paul Lamar

OK, here's one made by a R&D Drive Train Solutions for marine use...
very thin and could probably be bolted directly to the Mazda flex
plate. Its possible they have one that would mate to the RD2-C input
shaft (yeah, I'm dreaming.).

Mark

Where is the rubber? I see angular mis alignment capabilities but no
torsional flexibility.

Paul Lamar


The best is make your own, AC Spruce has 4130 .090" thick sheet 18 by
18 for $36. Cut a flex plate to fit the 20B ring gear with a plasma
cutter. Weld up a motor cycle type torsional damper. Use red silicon
rubber. Good to 500 F. Make a mold out of Teflon. Drill the rivets
out Tracy's spline flange and reuse that.

Make 2. I'll buy one for my 3 rotor TC project.


Paul Lamar

Paul,

I don't see what keeps the spline-plate from being forced against the psru
adapter plate and causing damage to the adapter plate and the spline plate,
and possibly the rear gearbox seal.  Can you explain?

Mark

Good point. One or two needle bearings back to back would work.

Make a welding jig to hold everything in alignment as it is tig welding.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.