Subject: motor cycle rear hub
From: rotaryeng
Date: 5/26/2013, 8:47 AM
To: AAA-rotaryeng



  Does anybody know about motor cycle rear hubs with rubber torque
  dampers?

  Make model and parts numbers.

  Paul Lamar

  Used on Honda 550/750 Bikes, Virg

  Thanks Virg

  Looks like the hot tip for a torque damper I think you need a
wheel
  as well.

  Paul Lamar


  Paul,

  Maybe these would be easier to adapt to our use.  They're used
in Mercedes,
  various models.  I would need one for a MB truck.  ;-)

  Mark

  We have already been down that road. They are too stiff. Also
quite thick.
  where as the bike can only be 2 inches long or so.

  You can try it again however. The Rotamax was a small one rotor
rotary.
  Run it on the ground for an hour or so and then inspect it
after every
  flight for awhile.


  Paul Lamar

OK, here's one made by a R&D Drive Train Solutions for marine
use... very
thin and could probably be bolted directly to the Mazda flex
plate. Its
possible they have one that would mate to the RD2-C input shaft
(yeah, I'm
dreaming.).

Mark

Where is the rubber?  I see angular mis alignment capabilities
but no torsional
flexibility.

Paul Lamar


The best is make your own, AC Spruce has 4130 .090" thick sheet
18 by 18 for $36. Cut a flex plate to fit the 20B ring gear with a
plasma cutter. Weld up a motor cycle type torsional damper.
Use red silicon rubber. Good to 500 F. Make a mold out of Teflon.
Drill the rivets out Tracy's  spline flange and reuse that.

Make 2. I'll buy one for my 3 rotor TC project.

Paul Lamar


Yes Paul Contact Velocity they are using it for damper shimmy on front wheel

JEAN PRUDHOMME

  The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
  http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
  Copyright 1998-2013 All world wide rights reserved.