Subject: motor cycle rear hub
From: rotaryeng
Date: 5/26/2013, 7:34 PM
To: AAA-rotaryeng


 Does anybody know about motor cycle rear hubs with rubber torque
 dampers?

 Make model and parts numbers.

 Paul Lamar

 Used on Honda 550/750 Bikes, Virg

 Thanks Virg

 Looks like the hot tip for a torque damper I think you need a wheel
 as well.

 Paul Lamar


 Paul,

 Maybe these would be easier to adapt to our use.  They're used in
 Mercedes,
 various models.  I would need one for a MB truck.  ;-)

 Mark

 We have already been down that road. They are too stiff. Also quite
 thick.
 where as the bike can only be 2 inches long or so.

 You can try it again however. The Rotamax was a small one rotor rotary.
 Run it on the ground for an hour or so and then inspect it after every
 flight for awhile.

 Paul Lamar

 A long time ago I sent you some pictures of my attempt at torsional
 resonance dampening. The primary unit was a top hat section of
 rubber/fabriclike a automoble tire. The bottom flange bolted to ring
 gear plate and the hole in the top of the hat was used to fit a female
 splined piece to drive the gearbox. The unit is mounted within the
 bell housing and has beeen run. The gearbox I am using has straight
 cut gears and before the dampener it howled  louder than the engine
 exhaust. After fitting the dampener, the gear noise disappeared. The
 pilot of the gearbox input shaft which goes into the excentric shaft
 bearing shows that the two shafts are not moving  in unison. Thus the
 rubber device is allowing some independent motion between the engine
 and the gearbox.
    chris smale


The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
 http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2013 All world wide rights reserved.