I know there have been rotary diesels made that were
self-supercharging, but I was wondering if the same could be done with
a 13B style engine. I was thinking along these lines:
The front rotor would have a custom housing with a mirrored p-port
setup such that it created an intake and compression event on both
sides of the housing. This compressed air would be ducted together
and then to the intake of the rear rotor giving you an nearly 2:1 PR
supercharge (there would be some losses). When compressed at ~9:1 in
the rear, the total CR would be around 18:1, which would be sufficient
for compression ignition. The leading plug could be replaced by a
direct injection nozzle, and the trailing plug could be a glow plug.
There would be some things to work out with sealing, housing
thickness, etc, to handle compression ignition, but I think it's
doable.
A quick guesstimation showed that this should produce around 100-120hp
at 7500 rpm counting the power needed for the compressor section.
Combined with a turbo, you could probably push it to 150-175...
turbocompound would be even better.
Any thoughts?
Josh
Diesel exhaust is hazardous to your health according to WHO ....AKA
World Health Organization.
A diesel rotary may not run at 7500 RPM because of burn rate issues.
Paul Lamar
Paul, found this image to illustrate how the compressor part would work...
Josh
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.