I know there have been rotary diesels made that were
self-supercharging, but I was wondering if the same could be done
with a 13B style engine. I was thinking along these lines:
The front rotor would have a custom housing with a mirrored p-port
setup such that it created an intake and compression event on both
sides of the housing. This compressed air would be ducted together
and then to the intake of the rear rotor giving you an nearly 2:1 PR
supercharge (there would be some losses). When compressed at ~9:1
in the rear, the total CR would be around 18:1, which would be
sufficient for compression ignition. The leading plug could be
replaced by a direct injection nozzle, and the trailing plug could be
a glow plug.
There would be some things to work out with sealing, housing
thickness, etc, to handle compression ignition, but I think it's
doable.
A quick guesstimation showed that this should produce around
100-120hp at 7500 rpm counting the power needed for the compressor
section. Combined with a turbo, you could probably push it to
150-175... turbocompound would be even better.
Any thoughts?
Josh
Diesel exhaust is hazardous to your health according to WHO ....AKA
World Health Organization. A diesel rotary may not run at 7500 RPM
because of burn rate issues.
Paul Lamar
Paul,
My intent was that it would be run primarily on Jet-A, which I
believe
burns a little cleaner, but I think in this case soot production is
not an issue. Even using diesel, it would produce far less soot than
any land based diesel truck, and if the exhaust is routed
properly, it
won't infiltrate the AC cabin.
I checked the flame speed for both diesel and Jet-A, and they are
both
faster than the rotor tip speed at 7500rpm... whether or not it will
actually work at that speed would need more sophisticated calculation
than I can do, or a try-and-see approach.
One thing I see that could pose a major problem is the loading the
e-shaft wasn't designed for due to the front rotor being used as a
compressor. The would be driving heavy loads on both sides of the
rear rotor, and I have no idea if the center section of the e-shaft
could handle that. My gut tells me it wouldn't be a problem... the
compressor should only require about 20-35hp.
This idea intrigues me a lot because of the rising cost of 100LL and
the poor availability of mogas at airports. Even if you end up using
an external positive displacement supercharger for the extra
compression it could be worth it, and you'd end up with more power
from running both rotors. Combine this concept with a turbocompound
unit, and it has the potential to be the most efficient aviation
powerplant yet.
Josh
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.