Subject: dampened flex plate for 13B and 20B
From: rotaryeng
Date: 5/30/2013, 3:10 PM
To: AAA-rotaryeng



   "I am in the process of making two three rotor units out of

   1/8 thick 4130 so if any one is interested in a 2 rotor .096
   version let me
   know.

   I will use one on the 3 rotor turbo compound engine.

   It will be the same group buy situation.

   We have an NC laser cutter located.

   Paul Lamar"

   Paul,

   I'd be interested in one 20 B plate and one 13 rew 3rd gen type
   plate; let
   me know developments..btw, $ in the mail to you for the oil pan
   today.

   Does this flex plate keep the ring gear in the same plane and
   distance as
   the stock ring gear? I plan on using the stock AT 13B and 20
   starters (AT
   only item).

   Marc


   Yep. That is the whole idea. Ring gear in stock position.

   Paul Lamar


   Anybody with a 13B flex plate handy please count the number
   of teeth and tell me the OD and ID of the ring gear.

   For the three rotor it is 125 teeth 320 mm OD and 291 mm ID.
   the width of the ring gear is 13 mm.

   You can use inches if you wish,


   Paul Lamar



Paul,

Someone can confirm this, but I'm pretty sure the OD and ID of the ring gears, and spacing fore/aft are the same for the 13b and 20b flex plates.
The difference is in the dish profile.  The RWS gearbox requires using a 13b flex plate as that is the only one that matches up to the flex-plate adapter that comes with the RWS gearboxes.

Mark S.


OK we will standardize on the 13 B flex plate dimensions.

Paul Lamar


This is the specs on the 13B flex plate ring gear I think.
So far I have not found a source for just the ring gear.

116 teeth 298 mm 11.73" OD  269 mm 10.59" ID

If you have a flex plate double check these numbers.

If I cannot find a ring gear and you  want one of these send me a flex plate with ring gear and we will separate the ring gear and use that.

A Nissan is 1231209600 is close at 11.61 OD 10.340 ID is close with 115 teeth same pitch I think. I should be able to buy a ring gear for that.

You might have to slot your mounting plate and move the starter in a fraction.

Paul Lamar

Paul:  My flywheel is still attached to the motor .. but I counted 125 teeth and 320mm in diameter.  the width was 3/8".

I did not measure the i.d; will do that tomorrow.

I have a 2004 renesis engine.

And, I am in for a dampner as well ...

payment enroute for the oil pan.


Kevin DeVore



Thanks Kevin.

Paul Lamar


My 13B  Model 86-92 Turbo 125 teeth, 320mm OD and ringear ID 290 and 10 mm thick

Le Roux Breytenbach

    The Rotary Engine News Letter. Powered by Linux.
    ACRE NL web site. http://www.rotaryeng.net
    You Tube http://tinyurl.com/beqqxas
    Copyright 1998-2013 All world wide rights reserved.