Subject: reverse spline plate damper Plan E
From: rotaryeng
Date: 5/31/2013, 12:57 PM
To: AAA-rotaryeng



Plan E. No flex plate. No warping. No welding. No run out. No dial indicator.

Bolt it directly to the counter weight. I have three guys with NC mills. Jeff, Larry and John. Mill the parts out of 6061 T6 bar stock
7.5 inch in diameter and bolt it on using six new 10 mm metric bolts.

It will be about $30 for material.

You just need to send me Tracy's spline plate so we can drill out the rivets and bolt it to the aluminum damper coupling with a bunch of screws.

Paul Lamar


Now there's simple for ya. Best idea yet? Lowest cost? Do we have a winner? C. Smith

Here are some preliminary 3D's

Paul Lamar


Paul,

I think we have a winner here!

I just heard that the newest RWS gearbox doesn't use any damper bushings.  In other words, it is a solid drive with no damping feature at all.  Does anyone know if this is true?

Mark

If true he is going down the wrong road.
If true Continental and Lyc should do away with the torsional dampers on the crankshafts :)
The second torsional damper on my Cont O-470 upped the TBO from 1500 hours to 2000 hours.

High rotational  inertia loads (props) on shafts and gear boxes has always been a problem.

Here are some more 3D's. a little more refinement is required.

Paul Lamar

Plan E=elegant!
Marc


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.