Subject: Latest iteration on the rubber coupling
From: rotaryeng
Date: 6/2/2013, 5:44 AM
To: AAA-rotaryeng



  I had to cut back the fins to clear the 10 mm bolt heads
  I still need one of Tracy's spline plates to get accurate
  dimensions off of it. Does anybody have one they can loan
  me?

  Also is anybody interested in testing this right now.
  You have got to have an engine and gear box running.

  If so I will find the Ford TX part Tracy made his spline plate
  from and buy one for testing.

  --

  Paul Lamar


 Paul,

 If nobody has a running engine on a test stand, I could test it on my
 3-rotor... ground runs only.

 And YES, I want one.

 Mark

 Great Mark. Best man for the job. You have the most power and torque
 of anybody.

 I did not find a spline plate but most of the big auto tranny shops
 in Ventura are closed today. I can order one from Slauson in LA on
 Monday.
 Jean Proudhome sent me a picture of the part Tracy cuts the spline
 plate out of. We will use that. No need to send yours Craig.

 I'll will check the dwgs carefully again and see if I can find
 some metric 10 MM flat head hex socket high strength bolts.
 That would do away with the notch in the fins.

 Paul Lamar

Hi Paul;
I thought I sent an email for something similar to this years ago.
Those parts appear to be Ford C6/E4OD/4R100 forward drums - there are
many variants.  Lots on ebay
The spline is not  full depth on some later 4R100? versions.

IIRC, these are powdered metal parts.  At least 1 person talked about
replacing the soft AL rivets in Tracy's splined adapter plate with bolts
- I'm curious to know if and how it held up?
The excess forward drum cylinder portions can be removed, to create the
splined plate, in a few minutes with a hacksaw blade with the drum
mounted in a lathe, and then finished.
There are also stronger aftermarket 4140 billet versions.

Since you are already planning to CNC custom parts, have you considered
integrating the damper directly with the counterweight, replacing or
modifying the CW to save more weight?
smaller flexplates/ring gears, button race clutches?

Cheers
Cary

To hog the counter weight and rubber coupling out of billet steel would
cost three or four times as much. Maybe ten times as much :)

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2013 All world wide rights reserved.