Subject: Exhaust coaxial muffler
From: rotaryeng
Date: 6/9/2013, 5:04 AM
To: AAA-rotaryeng


Paul, If you have it handy, how many holes are in the inner tube, and
what size?? I realize it is probably not that important, but it just
saves me trying to work out something I know nothing about. Now
sending my tangential muffler back to plan exhaust which will give
then the measurements so that the new pipes will fit exactly . Yes I
have heard that too, but should be close enough and they can reuse a
lot of the original fittings, so cost will be greatly reduced.

Neil.

I am guessing but the first 1/3rd on the inner pipe drill three
1/4 inch dia holes every 2 inches.


Next 1/3 3/8 inch dia holes every 2 inches.


Last 1/3 1/2 inch dia holes every 2 inches.

This is based on a guesstimate of the pressures in the inner pipe.

Start about a foot back from the start of the outer pipe.

In theory this is a jet engine so It should develop a slight amount
of thrust.

Another way of using some of the vast amount of waste energy in the
exhaust.


Paul Lamar

Oh, and when you put the holes in, take a rod , stick it into the
hole and pull it back towards the exit end if the pipe - to direct
the exhaust gases back towards the exit- like a cheese grater.

Brian Trubee


-- 
The Rotary Engine News Letter. Powered by Linux. ACRE NL web site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas Copyright 1998-2013 All world wide rights reserved.