http://www.ipmd.net/Introduction_to_powder_metallurgy/Properties_of_PM_Materials
"Fatigue strength
Both Press/Sinter Powder Metallurgy steels and Powder Forged
steels are capable of providing significant levels of fatigue
strength:
In the as-sintered condition, Press/Sinter PM steels can deliver
fatigue endurance limits of up to around 320 N/mm² (46,412
pound/square inch) in the rotating bend loading mode and up to
around 270 N/mm² (39,160 pound/square inch ) in the axial
loading mode (R = -1, Kt = 1).
Heat treatment can raise these values to up to around 540 N/mm²
78,320 pound/square inch and 460 N/mm² (66,717 pound/square
inch) respectively.
Powder forged steels can deliver fatigue endurance limits of up
to around 420 N/mm² (60,915 pound/square inch) in the rotating
bend loading mode and up to around 360 N/mm² (52,213 pound/square
inch) in the axial loading mode
(R = -1, Kt = 1).
Heat treatment can raise these values to up to around 635 N/mm2
(92,098 pound/square inch) and 560 N/mm² (81,221 pound/square inch)
respectively."
--------------------------------------------------------------------------------------------
The other powdered metal part in Tracy's 2.85:1 PSRU is the
bulkhead holding
the planetary ring gear stationary. This has sheared the 1/4
screws holding it to the PSRU housing. IMHO The low ductility and
hardness of PM was a factor in this occurrence along with the
torsional vibrations from the engine. The rubber coupling will
mitigate this effect. Drill these bolts out and replace them with
5/16th.
I would do it differently and not use the PM bulkhead.
I would come in from the OD with glorified 5/16th set screws and
also glue
it in with silicone rubber to provide a bit of torsional flexibility.
Some oversize indentations for the set screws can be drilled in
the OD of the ring
gear. If it is too hard for that EDM can be used to make the
indentations.
Paul Lamar