This is a time to climb to 10,000 meters record attempt. Time to
climb is all about power to weight ratio and the Wankel rotary engine
excels in that category.
Allan Tolle in a 300 HP Power Sport 2 rotor running on NOS and 100LL
in an RV3 holds the unofficial dead stop to 3000 feet record at just
under a minute.
Jim Mederer of Racing Beat fame is building the all aluminum (200
pounds bare) 2 rotor p-port turbo charged 650 HP engine.
Jim is a bit anal about rotor housing cooling hence the sprint car
V8 water pump :) To my knowledge Jim never installed a "cylinder
head" temperature gage so this is based on a guess of what the rotor
housing temperature might be. The drag racers get many runs out of
such an engine.
This is also a tribute to the robust Mazda Wankel engine. In street
form the most HP Mazda every sold was 280 HP. 650 HP or more is
normal for drag racing. This engine will not use NOS but it would be
good for at least an additional 100 HP.
If one pumped up an aircraft piston engine to this level one would
have a hand grenade in 15 seconds :)
The engine is being installed in an all ready flying Harmon (REAL!)
Rocket. The gear box is a Bell 47 helicopter final drive. First used
with a rotary back in 1973 by Dave Garber in his huff and puff Reno
racer. (Never got it to cool as that was long before my book on "How
to Cool Your Wankel").
Taking off in a high power to weight ratio prop plane is challenging
to say the least. One must feed the power in slowly but not too
slowly to get the record.
Russ McFarland, an expat American, living in New Castle Australia, is
sponsoring this project.
Now if I could only get him to sponsor a turbo compound rotary
....:)
Paul
Latest pictures.
They figure it is going to climb out at a 80 degree angle at 110 MPH.
Cooling by liquid spray on heat exchangers. Either water or alcohol.
I suspect alcohol or acetone would work better as Jim wants to
keep the coolant temperature down to an extraordinary 190 F.
Any total loss spray fluid must evaporate to extract a large
amount of heat.
BTW the turbo is equipped with a tach to keep the turbo turbine
blades from flying off.
Paul Lamar