Subject: 650 HP P-port turbo 2 rotor in Harmon Rocket Latest Picts
From: rotaryeng
Date: 6/11/2013, 3:20 AM
To: AAA-rotaryeng

This is a time to climb to 10,000 meters record attempt. Time to
climb is all about power to weight ratio and the Wankel rotary
engine excels in that category.


Allan Tolle in a 300 HP Power Sport 2 rotor running on NOS and
100LL in an RV3 holds the unofficial dead stop to 3000 feet record
at just under a minute.

Jim Mederer of Racing Beat fame is building the all aluminum (200
pounds bare) 2 rotor p-port turbo charged 650 HP engine.

Jim is a bit anal about rotor housing cooling hence the sprint car
V8 water pump :) To my knowledge Jim never installed a "cylinder
head" temperature gage so this is based on a guess of what the
rotor housing temperature might be. The drag racers get many runs
out of such an engine.

This is also a tribute to the robust Mazda Wankel engine. In
street form the most HP Mazda every sold was 280 HP. 650 HP or more
is normal for drag racing. This engine will not use NOS but it
would be good for at least an additional 100 HP.

If one pumped up an aircraft piston engine to this level one would
have a exploded hand grenade in 15 seconds :)

The engine is being installed in an all ready flying Harmon
(REAL!) Rocket. The gear box is a Bell 47 helicopter final drive.
First used with a rotary back in 1973 by Dave Garber in his huff
and puff Reno racer. (Never got it to cool as that was long before
my book on "How to Cool Your Wankel").

Taking off in a high power to weight ratio prop plane is
challenging to say the least. One must feed the power in slowly but
not too slowly to get the record.

Russ McFarland, an expat American, living in New Castle Australia,
is sponsoring this project.

Now if I could only get him to sponsor a turbo compound rotary
....:)

Paul


Latest pictures.

They figure it is going to climb out at a 80 degree angle at 110
MPH.

Cooling by liquid spray on heat exchangers. Either water or
alcohol. I suspect alcohol or acetone would work better as Jim
wants to keep the coolant temperature down to an extraordinary 190
F.

Any total loss spray fluid must evaporate to extract a large
amount of heat.

BTW the turbo is equipped with a tach to keep the turbo turbine
blades from flying off.


Paul Lamar

Hi Paul

Are they cooling the charge? Can't see anything in this pic unless
air to water inside that intake track. Do you know what boost they
plan on using? Must be pretty high to yield 650HP. What is the fuel,
perhaps its not what you guys call Gas.

Steve Izett

Probably alcohol for fuel. No intercooler required.
No idea of the exact  boost. Probably well over 60  or 70 inches
Hg.

BTW Jim Mederer I think holds the stock body land speed record
at 268 MPH in a 3rd gen RX7.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.