Subject: 650 HP P-port turbo 2 rotor in Harmon Rocket Latest Picts
From: rotaryeng
Date: 6/11/2013, 8:05 AM
To: AAA-rotaryeng



This is a time to climb to 10,000 meters record attempt. Time to
climb is all about power to weight ratio and the Wankel rotary
engine excels in that category.


Allan Tolle in a 300 HP Power Sport 2 rotor running on NOS and
100LL in an RV3 holds the unofficial dead stop to 3000 feet record
at just under a minute.

Jim Mederer of Racing Beat fame is building the all aluminum (200
pounds bare) 2 rotor p-port turbo charged 650 HP engine.

Jim is a bit anal about rotor housing cooling hence the sprint car
V8 water pump :) To my knowledge Jim never installed a "cylinder
head" temperature gage so this is based on a guess of what the
rotor housing temperature might be. The drag racers get many runs out
of such an engine.

This is also a tribute to the robust Mazda Wankel engine. In street
form the most HP Mazda every sold was 280 HP. 650 HP or more is
normal for drag racing. This engine will not use NOS but it would
be good for at least an additional 100 HP.

If one pumped up an aircraft piston engine to this level one would
have a exploded hand grenade in 15 seconds :)

The engine is being installed in an all ready flying Harmon (REAL!)
Rocket. The gear box is a Bell 47 helicopter final drive. First
used with a rotary back in 1973 by Dave Garber in his huff and puff
Reno racer. (Never got it to cool as that was long before my book on
"How to Cool Your Wankel").

Taking off in a high power to weight ratio prop plane is
challenging to say the least. One must feed the power in slowly but
not too slowly to get the record.

Russ McFarland, an expat American, living in New Castle Australia,
is sponsoring this project.

Now if I could only get him to sponsor a turbo compound rotary
....:)

Paul


Latest pictures.

They figure it is going to climb out at a 80 degree angle at 110
MPH.

Cooling by liquid spray on heat exchangers. Either water or
alcohol. I suspect alcohol or acetone would work better as Jim wants
to keep the coolant temperature down to an extraordinary 190 F.

Any total loss spray fluid must evaporate to extract a large amount
of heat.

BTW the turbo is equipped with a tach to keep the turbo turbine
blades from flying off.


Paul Lamar

The project is doomed. A Fram filter and the square Peterson oil
pump. I had three of those split open along the pressure section bolt
holes. I rebuilt it twice and lost both of those. Then sent it back
to Peterson for a pricey factory rebuild, and that one split open as
well. Peterson said it was my fault because I used 100 PSI. The
older round Peterson is just fine. I went back to a round Moroso
pump. No more problems.

Lynn E. Hanover

I'll send this to Jim :)

I will say this is not the first turbo 3 rotor Jim built. One
had over 1000 HP. He also built the one in the stock body
land speed record RX7.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.






-