Detroit Diesel started as GM Diesel prior to WW2. They had a 51
series that
I believe had an integral head. They also produced the 53, 71,
92 series
engines. They also had a 110 engine which was discontinued. I
have not seen
the 51 or 110 engines. They also produced 149 and EMD series.
The 149
engines were used in construction and marine and some power gen
applications. The EMD series had 645Ci per cylinder for use in
trains. Some
were used for power gen. The air box covers I believe were more
for core
sand removal from the intake air plenum area, but just happen to be
convenient to inspect the cylinder condition before doing a tune
up. They
did also produce an aluminum block 6-71.
Some of the diesel manufacturers used a glow plug and fuel
dripped or
injected into the intake to pre-heat for starting. Diesels with
a higher CR
start better because of the higher heat of the compressed air at
the point
of injection. Detroit Diesel also found better starting with
their DDEC
controlled engines due to the ability to retard the injection
point to TDC
.
I think Mazda is the only company producing a diesel with a CR
lower than
15:1 at this time. They use the VVT feature to introduce some
exhaust into
the intake air to help pre-heat it for warm up combined with
glow plugs to
get the initial combustion.
Dale Davies
Hello again!: besides the Rolls Royce two stage Compression
Ignition Wankel engines developed by D W Garside, and whose images
were previously send to this site, I've located the SAE papers
about the subject: 930683 , by Dankwart Eiermann, on a series of
small, Diesel fuel Wankel RCEs, and 870449 by Roy Kamo, about a
low compression Diesel engine.Regarding the YouTube video about a
narrow linear hole in the trochoid surface for the plug, instead
of the usual round and bigger one
http://www.youtube.com/watch?v=m3pCLjHZmhM
http://www.youtube.com/watch?v=sKrWB3aJeaU -A non-Wankel
RCE that works
a SAE paper by Marcos Langeani, 921444 proposes exactly the
opposite, and the attached patents by Kawasaki and Yamaha,
downloaded from ESPACENET also deal with related issues Thanks
for your attention, best regards, salut +
Jose Gros-Aymerich E-28033 Madrid, Spain